Replacing kitchen sink

 Hi all,

I'm replacing a kitchen sink, but I'm not sure about the metal strip
that's between the sink and formica countertop.  The sink is steel and
about 10 years old, and the reason I'm replacing it is because the
metal piece around the drain where pipe screws into is loose causing
water to leak under sink.  Plus with 10 years of nicks and dings it's
time to get something new.

So - will this metal piece be included with a new sink?  It looks like
it's cut exactly the size of the sink and I see no seams.  Also what
special do I do to hold the sink down?  I looked underneath it but I
don't see any clamps or screws holding it down.

Thanks for any suggestions on this... I'm replacing the sink tomorrow
(Sunday), so I'll post updates when I start with some pics.

Thanks again --

Alex

 

===> That's too bad; we've got a 50+ year old kitchen
sink and I guess they knew how to make them back then.
It's big, functional, and unavailable in any form even
close to it.  But, that aint' what you asked about -
sorry, guess I'm proud of it!  <g>  Please read on:


===> Yes, maybe, and maybe not.  It -should- be
included with the sink.  Sometimes they are sold
separately.  And sometimes they sinks don't need them
or aren't designed to use them.
   Be sure to ask when you buy, if the rim is important
to you (or the lil lady).
  It looks like

===> The seam is probably midline in the very backside
of the sink.  At least I've never seen one without a
seam, but it's surely possible.

 Also what

===> Depends on the sink design you choose to replace
it.  Sometimes it's a part of that ring you refer to,
and other times it's little clamps underneath, that fit
on sort of like the clips that hold storms into
aluminum storm doors.  These clips are the most common,
I think.
   I've seen a lot of sinks without hold-downs, but
I've no idea whether that's how they were intended or
not.  There aren't any on our kitchen sink.  Anyone can
move that sink, more power to 'em!  It must weigh 300
pounds or more!

 I looked underneath it but I

Good luck!

Pop

 The real issues here are two:

1 - How big the existing cut out is

2 - What shape the countertop is in the area currently covered up by
the sink where it's resting on the countertop.  By this, I mean if it's
in good shape, then the only limitation is the hole cutout.  If for
some reason the countertop under the existin lip  doesn't look good and
would show if the new sink lip is smaller, then that becomes a
limitation.

You should be able to find online documents/drawings for any of the
sinks you are interested in that will show the dimensions of the new
sink.

The new sink will come with whatever is needed to install it.  The ones
I've worked with have been all one piece.  Generally, a light sink,
like stainless steel, will have clamps that secure it from the bottom.
A heavy cast iron sink will not, they just rely on the weight plus
caulk to hold it in place.